Mostrando postagens com marcador Hull. Mostrar todas as postagens
Mostrando postagens com marcador Hull. Mostrar todas as postagens

terça-feira, 18 de outubro de 2011

Fillets and reinforcements

Since the bulkheads and the hull planks are joined together, now it's time to reinforce the inside part before turnnig the hull upside down. It's done by adding fillets of epoxy and flox on the inside corners and then adding one or more layers of fiberglass strips. The strips were cut in a way to make the fibers in a 45° angle, to increase shear stress resistance.


Epoxy + flox fillets on the inside corners

Fillet in detail
Joint of a bulkhead, the bottom and the side plank. Zip ties covered by flox
Fiberglass strips cut in 45º angles

Hand Lay up of the fiber strips
Final result

domingo, 16 de outubro de 2011

Building the boat up!

With all the parts done we started to put the pieces togheter. And the hull started to take form. We used the stitch and glue technique. I found it very fast and easy to do, it's very impressive how fast the boat just "appeared" in front of our eyes. We used some plastic zip ties, because the planks in foam and fiberglass were not very heavy. Just a little bit of strengh at the pull and the pieces were in place.
It was very nice to see the hull taking the apropriate shape as we put the bulkheads in the right place. The shape was just beautiful!
And is good to see that the guy how made the project did a very good job!

Joinnig the sides and the bottom

Zip ties doing their job

Sides togheter with the stern bulkhead

Placing the other bulkheads

Getting in the shape!

A view from behind

And the hull start's to rise!

After the bulkheads, now it was the time to finish the bottom and the side pannels. Not much to say, it was basically the same. We decided to do this with the manual lamination method since it's simpler and the bags for these large parts would be too big. The divinycell pannels needed to be glued togheter with flox (flocked cotton fibers).
After the cure was complete, it was a little awkward to trimm, because of the size, weight and flexibility of the pieces, but not a big deal.
Next step building the pieces toghether!

Drawing the bottom on the divinycell

Pannel cut (glued with flox)

Bottom laminated and trimmed ready to build